I was hoping to see if it was possible to add/modify something in the reports related to the buffer area. For example, if I want to run a report on a specific EEZ and increase the buffer area to go further out, I can run the report on the buffer area only (e.g. 10nm area outside of the EEZ). I was wondering if it would be possible to the same for when you go inside the EEZ. So when I take the slider and go -10nm inside the EEZ I am not able to only analyse the buffer area as it runs the report for the entire EEZ minus that 10nm buffer. This was raised at a country workshop because some vessels drift in to just inside of the EEZ and our government partners would want to see that activity of the sliver inside of the EEZ.